Glass Shelves; Loading Tips And Suggestions; Temperature Control - GE Profile PCR06BATSS Manuel D'utilisation Et D'installation

Masquer les pouces Voir aussi pour Profile PCR06BATSS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Controls and features—Beverage Center.
To remove, lift up on the back
of the shelf
Tilt the shelf at an angle while
removing or replacing
Place in slots when replacing
the shelf
Bottom drawer arrangement
4

Temperature Control

The operating temperatures of the beverage
center range from the low forties to the mid
fifties. This appliance is not a refrigerator and
does not maintain temperatures like a refrigerator
(below 41°F).
Do not install the beverage center where the
temperature will go below 55°F (13°C) or above
90°F (32°C).
As with any refrigeration-type product, there is a
slight temperature variance at different locations
within the cabinet.
The coolest area will be in the lower part of the
cabinet.
The cooler area will be in the middle section.

Glass Shelves

Tempered glass shelves in the beverage center
unit are removable for easy cleaning or for storing
larger items.
To remove a shelf, open the door completely to
avoid potential damage to the gasket. Lift up on the
back of the shelf slightly. Tilt the shelf to one side at
an angle while pulling forward.
To replace a shelf, open the door completely to
avoid potential damage to the gasket. Tilt the shelf
to one side at an angle and slide toward the back
wall, placing one side onto the shelf support. Place
the other side onto the opposite shelf support.
Ensure rear locking tabs are engaged. When
installed properly, the shelf will not slide forward
when gently pulled.

Loading Tips and Suggestions

• The bottom two full extension drawers hold six
bottles each and are loaded with necks facing
the rear. Tall bottles should not be loaded on the
bottom drawer because they may prevent the
door from closing.
The upper part of the cabinet is the warmest
section.
When the temperature is adjusted, allow 24 hours
for the unit to stabilize.
To set the control, turn it to the midpoint setting
(approximately 45ºF). Once the beverage center is
loaded, allow at least 24 hours before making any
adjustments to the initial setting.
NOTES:
• This unit is designed for storing and cooling
beverages. It is not intended for the storage of
perishable foods.
• The lowest temperatures are found on the
lower shelves/racks and toward the rear of the
shelves/racks.
• Do not allow children to climb, stand or hang
on the beverage center shelves or full extension
drawers. They could seriously injure themselves
and possibly cause damage to the beverage
center.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Profile pcr06watssPcr06batssPcr06watss

Table des Matières