Connecting A Cellular Phone; Connecting An Audio Device; Handsfree Calling; Receiving Calls - Sony MEX-BT2900 Mode D'emploi

Connecting a cellular phone

1
Be sure that both this unit and the
cellular phone are switched to
Bluetooth signal on.
2
Connect to this unit using the cellular
phone.
" "appears when the connection is made.
If you select the Bluetooth Phone source after
the connection is made, the network name
and the connected cellular phone name
appear in the display. To change display
items, press (DSPL).
Connecting the last-connected
cellular phone from this unit
1 Be sure the cellular phone is switched to
Bluetooth signal on.
2 Press (SOURCE/OFF) repeatedly until "BT
PHONE" appears.
3 Press (handsfree).
" " flashes while the connection is being
made. " " stays lit when the connection is
made.
Notes
• Some cellular phones require permission to access
their phonebook data during handsfree connection
to this unit. Obtain permission via the cellular phone.
• While streaming Bluetooth audio, you cannot
connect from this unit to the cellular phone. Connect
from the cellular phone to this unit instead. A
connecting noise may be heard over playback
sound.
Tips
• With Bluetooth signal on: when the ignition is turned
to on, this unit reconnects automatically to the last-
connected cellular phone. But automatic connection
also depends on the cellular phone's specification. If
automatic connection is not made, connect
manually.
• You can also select the Bluetooth Phone source by
press (CALL).
18

Connecting an audio device

1
Be sure that both this unit and the
audio device are switched to
Bluetooth signal on.
2
Connect to this unit using the audio
device.
" " appears when the connection is made.
Connecting the last-connected audio
device from this unit
1 Be sure the audio device is switched to
Bluetooth signal on.
2 Press (SOURCE/OFF) repeatedly until "BT
AUDIO" appears.
3 Press (6).
" " flashes while the connection is being
made. " " stays lit when the connection is
made.

Handsfree calling

Once the unit is connected to the cellular phone,
you can make/receive handsfree calls by
operating this unit.

Receiving calls

When receiving a call, a ringtone is output from
your car speakers. The name or the phone
number appear in the display.
1
Press (handsfree) when a call is
received with a ringtone.
The phone call starts.
Notes
• Depending on the cellular phone, caller name may
appear.
• The built-in microphone of this unit is located on the
rear of the front panel (page 12). Do not cover the
microphone with tape, etc.
Auto Answer setting
You can select an auto answer setting from
"OFF," "1 (about 3 seconds)" or "2 (about 10
seconds)" (page 23).
Ringtone setting
You can switch the ringtone from "1 (this unit)"
or "2 (cellular phone)" (page 23).
* Depending on the cellular phone, this unit's ringtone
may be output even if set to "2 (cellular phone)."