Honeywell 301C Manuel De L'utilisateur page 53

The bottom right portion contains the operand, which defines what
device or group of devices on which the Event will be based. The list
provides the following options:
OFF Used for status on binary inputs (ex.: used with 301ADI)
ON: Used for status on binary inputs (ex.: used with 301ADI)
Fault: Bases trigger on maintenance alarm, communication failure or
device failure
Alrm A: If the chosen device or group is in alarm mode, an event will be
triggered
The Coverage Period screen lets you define the period that will be
covered by the Event. (The time frames for each of these periods can
be defined in the controller Config menu.) This option provides two
further selection fields:
Day definition field: lets you select All day, Daytime, Nighttime
Week definition field: Weekend, Working Days, All week
1. Use the keypad up or down arrows to scroll to either All day or All
week
2. Press Enter to select. The value can now be changed
3. Use the keypad up ro down arrows to scroll through options (see
above)
4. Press Enter to select.
510324
4/07
3. Events
-Coverage Period-
All day
All week
301C User Manual
Honeywell
System Programming
001
Event Menu
51