Helite HIP' SAFE Manuel D'utilisation page 24

24
CO2 CARTRIDGE
The belt is sold with a new and usable CO2 cartridge ready to work.
To install a new one, you must screw it directly in the black cylinder.
Black cylinder
The cartridge is for single use only and must be replaced after each inflation.
We advise to store 1 or 2 cartridges and keep them available in the event of fall.
It is possible to order CO2 replacement cartridges on our website www.helite.com or at one
of our dealers.
CAUTION
• The CO2 cartridges are for single use only and must be replaced after each inflation.
• The CO2 cartridge must be a Helite branded cartridge ( GG 50cc / GG 60cc). Do not use any
other cartridge to replace the used one.
• The cartridge must be entirely screwed. Never connect the cartridge
before screwing it entirely in the black cylinder.
• The cartridge should be stored and used in temperatures below 45°C. Do not
leave full cartridges in the car in high temperatures for example.
• Never let the cartridge fall down.
• If rust or other corrosive marks appear on the outer surface of the cartridges, change them
immediately and discard the cartridge.
• Never cut the cartridge, do not throw into fire.
• Keep out of children's reach.
TABLE OF SIZE
The belt must fit perfectly over your hips to ensure an optimal protection. Please verify that
it is not too tight or too loose. The belt is available in five different sizes ( T1, T2, T3,T4 and
T5). It is also possible to adjust the belt thanks to the strap under the belt. To find your size,
you need to measure your waist (with clothes on) and look at the table below:
Waist line
Tour de taille
Taillenumfang
(in centimeters and
inches)
User Guide
Helite CO2 cartridge
Product size
T1 T2
82-91 cm
90-103 cm
(32-36 '')
(36-40 '')
/ Taille du produit / Produktgröße
T3
101-112 cm 110-124 cm
(40-44 '')
(44-49 '')
T4 T5
122-134 cm
(49-53'')