Helite HIP' SAFE Manuel D'utilisation page 21

3. Buckling the belt will turn the system ON
ON
HOW TO PLACE THE BELT CORRECTLY?
Pull the belt over your hips
and close it to activate the
system.
WRONG POSITIONS
Mauvais positionnement
The belt is not turned.
HOW TO KNOW IF HIP'SAFE IS ON THE RIGHT SIDE?
- The symbols "UP" and the figure
point upwards.
- A single "beep" when the system is
ready to function.
SYSTEM ON- OFF
Check if the belt is in the right
position. (Picto "Up" and the
figure are upward)
The belt is on the wrong
side (the arrow must
CORRECT
User Guide
point
upwards).
NOT CORRECT
-The symbols "UP" and the figure are
backwards.
- A 10 seconds continous beep.
- Red LED is on.
OFF
Turn and center the belt.
(Buckle on your back, arrow
on your front)
The belt is not centered.
21