Normal Use; Contents; Technical Data - AEG ST 500 Mode D'emploi

Normal use

The power inverter is intended to convert 12 V direct current voltage to
▪
alternating current voltage 230 V/50 Hz and/or
▪
direct current voltage of 5 V/max. 500 ma (2.0 uSB).
The power inverter is only intended for permanent installation.
This device is not intended for use by children or persons with limited mental capacity or lacking experience and/or
lacking expertise. Children should be supervised to ensure they do not play with the device.
This device is not intended for commercial use.
any other use or modification of the device is considered improper and involves significant risks. The manufacturer
assumes no liability for damages due to improper use.

Contents

Be sure to verify contents immediately upon opening the product. Check the product and all parts for damage. do not
use a defective product or parts.
▪
power inverter with 12 V connector
▪
remote control module
▪
2 cables with ring lugs/clamps
▪
Operating instructions
please make all relevant documentation available to other users!

Technical data

nominal input voltage
Output voltage
wave form
ambient temperature
Over-voltage protection
under-voltage protection
Over-heating protection
Input voltage range
low battery shutdown
12 V dC / 50 Hz
230 V
Sinusoidal wave
0˚C - 30˚C
15,5 V ±0,5 V
10 V ±0,5 V
±68 ˚C
10 - 15 V dC
10 V dC ±0,5 V
gB 19