Placement Of The Cooling Water - Husqvarna CS 2512 Manuel D'utilisation

Operator's Manual CS 2512
5. Thread the wire around the drive wheel and out
through the hole by the second swivel wheel. The
swivel wheel can rotate and be locked in the required
position by turning the marked (A) knobs.
6. Before the joints on the wire are connected, the wire
should be twisted 1 to 2 turns per metre wire used. It is
important to twist the wire in the same direction as it is
spun. This is to give as even wear as possible on the
wire's diamond segments.
7. Lock the wire with a pin. If there are no end sleeves on
the wire, these must be spliced on to the wire. A
special pair of wire pliers must be used. If you are
unsure about which model you should use, contact
your Husqvarna dealer.
8. When the wire is routed correctly it should run through
the machine as in the figure below:
CAUTION
A used wire must always be run in the same
direction, as it was previously run in order to
prevent unnecessary wear.

Placement of the cooling water

Husqvarna CS 2512 is equipped with two outlets for the
cooling water. Ideally,Husqvarna water spears can be
connected to these. The water spears are then placed
where the wire enters the concrete. In this way the wire
takes water with it into the cut, which results in the
concrete dust binding and that the wire is cooled
efficiently.
a
CAUTION
In order for the water to cool the wire as
intended during cutting, it is essential to adjust
the position of the cooling water as the
material is cut. Remember to always stop the
machine when you do this.
In addition to the cooling water from the water spear, the
wire is rinsed by the two swivel wheels on the machine.
This is to keep the wire as clean as possible, which means
that the saw can work with less friction losses and greater
efficiency as the wire becomes cleaner.
WATER
WATER
English - 19