What Is What - Husqvarna CS 2512 Manuel D'utilisation

Masquer les pouces Voir aussi pour CS 2512:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operator's Manual CS 2512

What is what

The saw consists of the following component parts:
1. Hydraulic motor
The machine is powered by a 60 cubic centimetre
motor. The motor has two parts, one of 50 cubic
centimetres and a smaller part of 10. Two gears are
obtained by using either just the large motor or both
the large and small motors together. The two gears
give different speeds, yet the same power.
2. Hydraulic hose connections
The hydraulic flow in the two large hoses drives the
machine's motor and with that the wire. The flow in the
two smaller hoses drives the magazine cylinder.
3. Drive wheel
Transfers the motive force from the motor to the wire.
The drive wheel is 400 mm in diameter and is covered
with replaceable rubber to give as good grip as
possible between the drive wheel and wire.
The drive wheel forms together with the hydraulic
motor and the hydraulic connections the drive wheel
unit. The drive wheel unit is adjusted depending on
how many wheel sets are used in the magazine. These
can easily be dismantled to give a lighter machine
during transporting.
6
7
4
9
14
8
15
5
4. Wire magazine
Tensions the wire and stores recovered wire. The wire
magazine has a capacity to store a maximum of 12
metres of wire (2.4 metres per wheel set).
5. Magazine cylinder
The magazine cylinder tensions the wire in the
magazine and with that governs cutting. The pressure
in the cylinder is adjusted by means of the pressure
reduction block fitted on PP 455E or RC 455.
6. Guard
The machine has a two-piece guard. A fixed part made
of sheet metal and a folding cover made of plastic and
metal. The guard is easy to remove, e.g. when the wire
is threaded, it should always be fitted in position when
cutting.
7. Lifting handle
The folding handle is the perfect aid when transporting
the machine.
8. Adjustable feet
Adjusted so the saw stands firmly. In total, the saw
features 10 feet, six for horizontal cutting and four for
the vertical position.
4
11
3
1
2
12
14
10
English - 11

Publicité

Table des Matières
loading

Table des Matières