Installing The Microphone; Mounting On The Sun Visor - Pioneer MVH-290BT Mode D'emploi

2
Screw in one screw on each side to
hold the unit in place.
Tapping screw (φ5 mm × 9 mm)
Mounting bracket
Dashboard or console
Using the included bracket
Check to make sure that the included
bracket matches your particular
model of vehicle and then attach it to
the unit as shown below.
Screw
Bracket
Removing the unit (installed
with the supplied mounting
sleeve)
1
Remove the trim ring.
Trim ring
Notched tab
• Releasing the front panel allows
easier access to the trim ring.
• When reattaching the trim ring,
point the side with the notched
tab down.
2
Insert the supplied extraction
keys into both sides of the unit
until they click into place.
3
Pull the unit out of the dashboard.
To secure the front panel
The front panel can be secured with
the supplied screw.
Screw
Installing the
microphone
• Install the microphone in a place
where its direction and distance
from the driver make it easiest to
pick up the driver's voice.
• Be sure to turn off (ACC OFF) the
product before connecting the
microphone.

Mounting on the sun visor

1
Fit the microphone into the
microphone clip.
Microphone
Microphone clip
2
Mount the microphone clip to the
sun visor.
Microphone clip
Clamps
Use separately sold clamps to
secure the lead where
necessary inside the vehicle.
Install the microphone on the sun
visor when it is in the up position. It
cannot recognize the driver's voice
if the sun visor is in the down
position.
En
15