Bluetooth; Bluetooth Connection; Bluetooth Telephone - Pioneer MVH-290BT Mode D'emploi

Bluetooth

Bluetooth connection

1
Turn on the Bluetooth function of the device.
2
Press to display the phone menu.
3
Turn the M.C. dial to select [BT SETTING], then press to confirm.
4
Turn the M.C. dial to select [ADD DEVICE], then press to confirm.
The unit starts to search for available devices.
• To cancel searching, press the M.C. dial.
• If the desired device is not in the list, select [RE-SEARCH].
• If there is no device available, [NOT FOUND] appears in the display.
5
Turn the M.C. dial to select a device, then press to confirm.
Press and hold the M.C. dial to switch the displayed device information
between the Bluetooth device address and device name.
6
Select [Pioneer BT Unit] shown in the device display.
7
Make sure the same 6-digit number appears on this unit and the device,
then select "Yes" on the device.
NOTES
• Depending on the device, the PIN code is required in step 7. In this case, input [0000].
• Only one single device can be paired/registered at any one time. The previously paired/
registered phonebook and preset information is overwritten/deleted when a new device
is paired/registered to this unit.
TIP
The Bluetooth connection can be also made by detecting the unit from the Bluetooth
device. To do so, [VISIBLE] in the Bluetooth settings needs to be set to [ON]. For details on a
Bluetooth device operations, refer to the operating instructions supplied with the
Bluetooth device.
8
En
Bluetooth settings
Menu Item Description
BT CONNECT Display the paired Bluetooth devices. "*" appears on the
device name when the Bluetooth connection is
[ON], [OFF]
established.
ADD DEVICE Register a new device.
A.CONN Select [ON] to connect to a Bluetooth device
automatically.
[ON], [OFF]
VISIBLE Select [ON] so that a Bluetooth device can detect the
unit when the unit is connected via Bluetooth to another
[ON], [OFF]
device.
PIN CODE Change the PIN code.
1 Press the M.C. dial to display the setting mode.
2 Turn the M.C. dial to select a number.
3 Press the M.C. dial to move the cursor to the next
position.
4 After inputting the PIN code, press and hold the M.C.
dial.
After inputting the PIN code, pressing the M.C. dial
returns you to the PIN code input display, and you can
change the PIN code.
DEV. INFO Switch the device information on the display between
the device name and Bluetooth device address.

Bluetooth telephone

First, make a Bluetooth connection with the Bluetooth telephone (page 8).
Important
• Leaving the unit on standby to connect to your phone via Bluetooth while the engine is
not running can drain the vehicle's battery.
• Be sure to park your vehicle in a safe place and apply the parking brake before operation.