Viking MR 4082 Manuel D'utilisation page 101

Fit V-belt (2) onto V-belt pulley (6).
When fitting, ensure that the V-belt is
installed correctly (not twisted).
● Slowly release V-belt tensioner lever (5)
and ensure that the V-belt is routed
correctly in the V-belt pulley.
● Install the discharge chute. (
● Install the grass catcher box. (
Risk of injury:
After attaching the mowing deck,
perform an operational check.
Ensure that no other persons,
particularly children or animals are
in the vicinity. Only perform the
operational check when the user is
sitting on the machine.
Installing rear V-belt cover
Danger of burns:
Allow the machine, particularly the
exhaust system to cool down
completely before installing the rear
V-belt cover.
● Select the lowest cutting level.
0478 193 9901 A - EN
13.4)
11.9)
Insert the rear V-belt cover (1) with the
retaining device at the locating lug (2) on
the gearbox (3) in direction of arrow.
Push rear V-belt cover (1) upwards and
hold. Turn the closure screw (2) clockwise
through 90°.
Note
After installing, check that the rear
V-belt cover is seated securely.
Avoid damage to the machine.
After installation, the V-belt must be
free and must not contact the rear
V-belt cover.
Check this visually.
99