Unpacking; Preparing; Installation - Tetra AquaArt Notice D'utilisation

Unpacking

ATTENTION!
Damage to the aquarium cover and
glass breakage due to improper
unpacking.
Only lift the aquarium by the lower
frame.
Use a second person to help lift and
transport the aquarium.
Open the packaging.
Open the cover (Fig. A, 1).
Remove the enclosed accessories and
the brochures from the aquarium.
Store the accessories and the brochures
in a secure location.
Close the cover.
Tilt the packaging box slightly.
Grip the aquarium by the lower frame.
Carefully lift it out of the packaging.
Place it down on a flat surface.

Preparing

ATTENTION!
Incorrect cleaning may damage the
aquarium or poison the tank contents.
Never use any hard, pointed or
sharp objects for cleaning purposes.
Use soft cloths or sponges.
Use only clean water or special
aquarium cleaning products for
cleaning purposes. These are
available from your stockist.
Particularly the corners of the tank
must be cleaned carefully to prevent
damage to the glued joints of the
glass walls.
English operating instructions
To check the aquarium for leaks, fill it with
water.
Fill the aquarium with clean water to
cover the vertical face of the top frame.
Do not fill to the point that water flows
over the top of the frame.
Leave the aquarium filled for 24 hours.
Check whether there are any leaks.
If the aquarium is leaking, empty it and
exchange it at your retailer.
If it is not leaking, empty it and position it
in its permanent installation location.

Installation

ATTENTION!
Damage to the aquarium and glass
breakage due to improper transport.
Empty the aquarium each time
before it is transported.
Use a second person to help lift and
transport the aquarium.
Lift the aquarium by the lower frame
only.
ATTENTION!
Damage to the aquarium due to the
selection of an unsuitable installation
location.
Make sure that the installation
location has the necessary load-
bearing capability. Permanent
location must be strong enough for
at least three times the estimated
mass of the filled aquarium.
Information on this can be obtained
in the section entitled Technical
Data from page 19
Make sure that the installation
location is flat, level and waterproof.
Earthed 230 V ~ 50 Hz sockets for the
electrical accessories must be located in
the vicinity of the installation location.
15