Prevention Of Damage; Unpacking And Installation - Tetra AquaArt Explorer Line 30 l Notice D'utilisation

• Unwind the full length of the power cables for all
the electrical devices in the aquarium. Do not kink
or crush the power cables.
• The mains cables for all the electrical devices in
the aquarium must be easily accessible so that the
plugs can be disconnected from the power supply
quickly in an emergency.
• Pull only on the plug to remove it from the socket –
do not pull on the power cable.
• Do not use the aquarium if the electrical devices in
it or their plugs are damaged.
• Never repair or modify the electrical devices
without authorisation. Electrical work may be
carried out only by the Tetra Technik Service
Center or trained electricians.
Prevention of asphyxiation
• Do not allow children to play with packaging films.
Prevention of cuts
• If any glass parts of the aquarium are broken, there
is a danger of cuts.
− Never touch the edges of shards of glass.
− Wear gloves.
− Remove all shards of glass carefully.

Prevention of damage

• Never transport the aquarium when it is filled.
• Only clean the aquarium with soft cloths or
sponges.
• For cleaning purposes, use clean water or special
cleaning products for aquaria.

Unpacking and installation

There must be properly installed and earthed sockets
(230 V ~ 50 Hz) near the installation site of the
aquarium for the electrical devices in it.
English translation of the original German instructions
CAUTION
Shards of glass can cause cuts.
 Ensure that you do not break the tank.
 Do not touch the shards of glass if the tank
breaks.
 Wear gloves.
 Remove all shards of glass carefully.
ATTENTION!
The aquarium lid may be damaged and the
glass broken if you unpack it incorrectly.
 Lift the aquarium by the frame only.
 Always lift and transport the aquarium with
another person.
 Open the packaging.
 Carefully lift the aquarium out of the packaging.
ATTENTION!
The aquarium may be damaged if you select an
unsuitable position for it.
 Ensure that the position is flat, horizontal
and waterproof.
 Ensure that the position for it is capable of
taking the weight of the unit.
The load capacity of the installation position must be
high enough to support three times the filled weight
of the aquarium. Information about the gross weight
is available in the section entitled
starting on page 17.
 Place the aquarium with the frame at the bottom in
the required position.
 Take out all the parts that are in the tank.
Technical data
13