Connecting And Starting; Cleaning - Tetra AquaArt Explorer Line 30 l Notice D'utilisation

Masquer les pouces Voir aussi pour AquaArt Explorer Line 30 l:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
 Remove the aquarium lid.
 Select a position to install the filter box on the
inside of the tank which is not curved.
 Ensure that you keep the filter the required
distances from the base and from equipment in the
aquarium.
The required distances are set out in the attached
instructions for the filter box.
 Ensure that you satisfy the minimum immersion
depth (as specified on the outside of the filter box).
 Secure the filter box vertically on the inside of the
tank as shown in the instructions for the filter box.
 Install the heating element in the filter box as
described in the instructions for the filter box.
Upon delivery, the cable guides and optional
positions for electrical devices in the aquarium lid are
closed with covers. The covers can be removed by
hand or with a pair of pliers.
ATTENTION!
The aquarium lid may be damaged if too much
force is used to remove a cover.
 Score the edges of the cover with a sharp
knife before you remove the cover.
 Remove the cover carefully.
 If the filter box is installed level with the aquarium
lid, carefully remove the cover from the
corresponding optional position in the aquarium lid
(Figures B and C).
 If the filter box is installed below the aquarium lid,
carefully remove the covers from the cable guides
for the mains cables of the filter and heating
element (Figures B and C).
 If the cable guides or option positions have sharp
edges, smooth them with a small file.
 Route the mains cables for the filter and heating
element upwards out of the aquarium.
 Follow the attached instructions for the filter box,
filter and heating element to complete the
remainder of the installation work.
English translation of the original German instructions
Installing additional electrical
devices
You can install additional electrical devices (for
example heating elements) in the aquarium if
required.
 Install electrical devices as described in the
relevant instructions for use and other instructions
supplied by the manufacturer.
 Carefully remove the covers from the required
cable guides and optional positions in the
aquarium lid (Figures B and C).
 Proceed as described in the previous section.

Connecting and starting

DANGER
Danger of death from electric shock.
 Check all the electrical devices in the
aquarium and their mains cable for
breakages, notches and other visible signs of
damage.
 Do not start to use the aquarium if any
electrical devices or mains cables are
damaged.
 Use only correctly installed earthed sockets
(230 V ~ 50 Hz) to supply power.
 Start the electrical devices installed in the
aquarium as described in the attached instructions.

Cleaning

DANGER
Danger of death from electric shock.
 Disconnect all the electrical devices in the
aquarium.
 Never reach into the water when the
electrical devices are connected to the
mains supply.
 Pull out the plugs of all the electrical devices
installed in the aquarium.
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Aquaart explorer line 60 l

Table des Matières