What To Do If; Installation - Zanussi ZOB35301 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

lation the surface of the glass panel frame on
the screen-printing zones is not rough when
you touch it.
Make sure that you install the internal glass
panel in the seats correctly. Refer to the illustra-
tion.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven lamp does not operate.
The display shows 12.00.
Steam and condensation settle on
the food and in the oven.
If you cannot find a solution to the problem
yourself, contact your dealer or the service cen-
tre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Installation

Warning! Refer to the Safety chapters.
www.zanussi.com
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not
set.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
There was a power cut.
You left the dish in the oven for
too long.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity.
Remedy
Activate the appliance.
Set the clock.
Make sure that the settings are
correct.
Do a check of the fuse. If the fuse
is released more than one time,
contact a qualified electrician.
Replace the oven lamp.
Set the clock.
Do not keep the dishes in the
oven for longer than 15 - 20 mi-
nutes after the cooking ends.
.........................................
.........................................
.........................................
15

Publicité

Chapitres

Table des Matières
loading

Table des Matières