Functional Description - Makita GD0801C Manuel D'installation

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch lever actuates properly and returns
to the "OFF" position when released.
Do not pull the switch lever forcibly without pulling
•
in the lock-off lever. This may cause switch
breakage.
1
015004
To prevent the switch lever from accidentally pulled, a
lock-off lever is provided.
1
015009
To start the tool, pull the lock-off lever toward the
operator and then pull the switch lever. Release the
switch lever to stop.
Speed adjusting dial
015005
The tool speed can be changed by turning the speed
adjusting dial to a given number setting from 1 to 5.
1. Lock-off lever
1. Lock-off lever
2. Switch lever
2
1. Speed adjusting
dial
1
Higher speed is obtained when the dial is turned in the
direction of number 5. And lower speed is obtained
when it is turned in the direction of number 1.
Refer to the table for the relationship between the
number settings on the dial and the approximate tool
speed.
GD0801C
Number
1 - 2 7,000 - 10,000
2 - 3 10,000 - 17,000
3 - 4 17,000 - 24,000
4 - 5
24,000 - 29,000
014991
CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded,
resulting in tool malfunction.
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or
the speed adjusting function may no longer work.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing the side handle
Always use the side handle to ensure operating safety.
1
015006
Install the side handle on the tool barrel, then tighten the
handle by turning clockwise at the desired position.
Installing or removing wheel point
1
4
5
015007
6
GD0811C
RPM RPM
1,800 - 2,400
2,400 - 4,100
4,100 - 5,800
5,800 - 7,000
1. Side handle
1. Wrench 19
2. Wrench 13
3. Collet nut
4. Tighten
5. Loosen
2
3