Functional Description - Makita 4112H Manuel D'instruction

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Adjusting the depth of cut
1
3
004377
Loosen the wing bolt on the depth guide and move the
base up or down. At the desired depth of cut, secure the
base by tightening the wing bolt.
Only case you adjust the cutting depth to the maximum
one, always be sure to do the adjustment after
adjustment of the wheel guard.
Securing wheel guard
2
004014
CAUTION:
The wheel guard must be adjusted on the tool so
•
that the closed side of the guard always points
toward the operator.
The wheel guard can be adjusted about 80 degrees,
after you loosen the clamping nut. Adjust to the desired
angle, then secure the clamping nut.
1. Wing bolt
2. Base
3. Cutting depth
2
1. Clamping nut
1
2. Wheel guard
Switch action
A
1
B
2
004015
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
For tool with the lock-on switch (for other than US
and Canada model)
CAUTION:
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, simply pull the switch trigger. (A
direction) Release the switch trigger to stop.
For continuous operation, pull the switch trigger (A
direction), push in the lock lever(B direction) and then
release the switch trigger.
To stop the tool from the locked position, pull the switch
trigger (A direction) fully, then release it.
For tool with the lock-off switch (for US and Canada
model)
CAUTION:
Do not pull the switch trigger hard without pressing
•
the lock lever. This can cause switch breakage.
To prevent the switch trigger from accidentally pulled, a
lock lever is provided.
To start the tool, push in the lock lever (in the B
direction) and then pull the switch trigger (in the A
direction). Release the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
6
1. Switch trigger
2. Lock lever