Cable Routing - YT Industries Decoy 29 Mode D'emploi

Observe the minimum insertion depth of the
10.
dropper post. You can find additional infor-
mation in the manufacturer's manual.
To remove and replace the dropper post you
must remove the battery and release the ca-
ble clamp in the downtube. The cable must
then be re-positioned properly and the cable
clamp secured again.
Failure to do so may cause damage to the
cable routing of the seat post.
TIP! How to set the correct saddle height: Sit
on the saddle, place your heel on the pedal
and rotate the crank to the lowest positi-
on. Your leg should be fully straight in this
situation.
4 6 y t
SEAT POST

CABLE ROUTING

Light cable
Electrical wire
Power cable
Dropper post
Brake cable
Shift cable