Make sure that the bike is properly position on
3.1.1
the rear axle stand.
Use the torque wrench to properly fasten the
3.1.4
derailleur bolt. Make sure that the tab of the
derailleurs rests against the corresponding
tab on the derailleur hanger. Hold the derail-
leur firmly in position with your other hand to
avoid cross-threading and to make sure no
gap is left.
3 8 y t
REAR DERAILLEUR ASSEMBLY
SH IMANO DEORE XT // SLX
Carefully remove the cable tie with a wire cut-
3.1.2
ter. Then remove the bubble wrap as well as
the protective foam from the rear derailleur.
Screw the derailleur to the derailleur hanger
3.1.3
(5mm allen key).
Pl ea se f ol l ow th e
torque spe ci f i cati ons of
the ma nufacture rs:
Rear derailleur screw //
8 – 10 Nm