Beta 960EPC Mode D'emploi page 8

INSTRUCTIONS FOR USE
KIT FOR REMOVING GLOW PLUG ELECTRODE M10X1 - M10X1.25 - M9X1 - M8X1
PARTS:
Ref. Description
A Glow plug guide M10x1
B Glow plug guide M10x1.25
C Glow plug guide M9x1
D
Glow plug guide M8x1
E
Pulling hexagon (15 mm)
F
Pulling rod M4
G
Pulling rod M3
H Anti-friction washer
I Pulling notch
L Tap M4 with fitted extension (special application)
M Drill Ø 3.2 with fitted extension (special application)
N Tap M3 with fitted extension
O Drill Ø 2.5 with fitted extension
P Tap M4 with fitted extension
Q Drill Ø 3.2 with fitted extension
Minimum outside diameter of electrode tip = Ø 4.3
Maximum diameter of internal hole = Ø 3
ONLY FOR SPECIAL APPLICATION WITH TOOLS
L-M
TOOLS
THESE ENGINES ARE FITTED WITH GLOW PLUGS M8x1, WHICH ARE PECULIAR IN THAT THE
ELECTRODE TIPS ARE THE SAME AS THOSE OF GLOW PLUGS M10
8
- SPECIAL APPLICATION -
MAKE IT POSSIBLE TO REMOVE THE TIPS OF SUCH GLOW PLUGS
AS SHOWN IN THE "APPLICATION" TABLE BELOW.
Crack area


EN
Q.ty
1
1
1
1
1
1
1
2
1
1
1
1
1
1
1
 
L – M