To Start The Product - Husqvarna FS5000 D Manuel D'utilisation

To set the cutting depth
1. Push the switch for cutting depth adjustment down to
lower the cutting blade until it touches the surface.
This is the start position for the cutting depth.
CAUTION: Do not lower the cutting
blade too quickly. If the cutting blade hits
the surface with force, it can cause
damage to the cutting blade. Decrease
the speed with the knob for adjustment
of the blade lowering speed.
2. Push the reset button for the blade depth stop on the
control panel. The cutting depth value is set to 0
in./mm on the display.
12
14
5.0
WORKING HOURS
18 110
V
CURRENT: STOP:
0 mm 0 mm
3. Push the button adjacent to the symbol for blade
depth stop. The symbol on the display changes color
to show that the function is engaged.
180
150 210
110 250
˚F
22
180
150 210
250
˚F
4. Turn the knob for adjustment of the blade depth stop
until the correct cutting depth shows on the display.
During operation, the cutting blade is not lowered
more than the set cutting depth.
10
8
RPM
5. If it is necessary to increase the cutting depth, do 1
of these procedures:
a) Turn the knob for adjustment of the blade depth
stop to set a new cutting depth.
b) Push the button adjacent to the symbol for blade
depth stop to disengage the function. The symbol
on the display changes color to show that the
function is disengaged.

To start the product

1. Connect the water inlet to a water supply.
2. Close the water valve.
RESET
3. Set the lever for speed control to the stop position.
4. Make sure that the transmission bypass valve is
closed. Refer to
3 for the position of the transmission bypass valve.
150 210
14
5.0
18 WORKING HOURS 110 250
V ˚F
CURRENT: STOP:
0 cm 4 cm
CAUTION: Always do a check that the
cutting depth is correct. The blade depth
stop helps you to get the correct cutting
depth but only gives an indication of the
depth value.
Product overview, left side on page
1143 - 002 - 08.07.2019
RESET
DEPTH