Husqvarna FS5000 D Manuel D'utilisation page 28

To clean the radiator
CAUTION: Obey the instructions. Incorrect
procedure can cause damage to the cooling
fins.
• Use compressed air to clean the cooling fins.
• If it is necessary, use a high-pressure washer and a
weak cleaning agent.
• Spray directly on the radiator, in parallel to the
cooling fins.
• Keep a minimum distance of 40 cm/15.75 in.
between the cooling fins and the nozzle for the high-
pressure washer or air flow.
To clean the control panel
CAUTION: Do not use a high-pressure
washer to clean the control panel.
• Clean electrical components with a cloth or with
compressed air.
• Clean the control panel with a moist cloth.
To clean the engine
• Keep a minimum distance of 40 cm/15.75 in.
between the nozzle and the engine and engine
components.
• Be careful when you clean the engine, especially
near electrical components. Do not spray water
directly at electrical components.
• Do not point the water directly into the exhaust pipe
or the engine air filter.
To do after you clean the product
• Blow electrical terminals dry with compressed air.
• Let the product become fully dry before you start the
engine.
To do a check of the radiator coolant
level
WARNING: Risk of burn injuries. Let the
engine become cool before you open the
radiator coolant lid.
28
1. Examine the radiator coolant level at the container
for radiator coolant spill. The coolant level is correct
when it is between the 2 marks.
2. If the radiator coolant level is too low, remove the lid
and fill until the level is correct. Refer to
data on page 42 for correct radiator coolant type
and mixture.
To do a check of the engine oil level
To read the oil level correctly the product must be in the
correct position.
1. Make sure that the cutting blade is removed and that
the product is level when you examine the engine oil
level.
2. Remove the dipstick from the oil tank.
3. Clean the oil from the dipstick.
Technical
1143 - 002 - 08.07.2019