Water Hardness Setting; Child Lock - F.Bertazzoni PROCS30X Guide De L'utilisateur

EN
Basic settings

Water Hardness setting

The system can be optimised for households with very soft water (also through using a water softening
appliance) and very hard water, by changing the user settings to the relevant range of water hardness
(see table below). To set the water hardness parameter, proceed as follows:
(The appliance features a system that automatically indicates when it is time to descale, showing the
message "".)
1. Rotate the Function Selector knob to the
position corresponding
Hardness Setting / Descaling function (not
necessary after connecting the device to the
network, or after a power failure).The water
hardness indicator light begins to flash.
Type
Soft water
Medium water
Hard water

Child Lock

The oven can be blocked against improper use (e.g., to prevent children from using it).
1. To block, the oven press the Stop key for 3
seconds. The display shows the Safety
Block indicator light. If a key is pressed
now, the the oven will not operate.
9
to the
Ca + Mg English deg.
(ppm) [°eH]
0 to 150 0 to 11
151 to 350 12 to 25
501 to 500 26 to 35
2. Turn the "+" / "-" Selector Knob to set the
Water correct water hardness parameter value,
according to the below table.
3. Press the OK key to set the parameter (or
wait until the parameter is set by time-out).
The clock is displayed.
Water hardness
French deg.
[°dF]
0 to 15
16 to 35
36 to 50
2. To unlock, press again the Stop key for 3
seconds.
German deg.
Display
[°dH]
0 to 8 SOFT
9 to 20 MED
21 to 28 HARD