Basic Settings; Initial Settings; Setting The Clock; Water Hardness Setting - F.Bertazzoni F45CONVAPX Mode D'emploi

EN

Basic settings

Initial Settings

After your steam oven is first plugged in or after a
power failure, the clock display will flash to
indicate that the time shown is not correct.
The oven will not operate until the clock, and the
water hardness parameter is set.

Setting the clock

To set the clock, proceed as follows:
1. Press the Clock key. The hour numbers will start to
flash (not necessary if your Steam oven is first
plugged in or after a power failure).
2. Press the "+" and "–" to set the correct hour value.
Hiding/Displaying the Clock
If the clock display disturbs you, you can hide it by
pressing the Clock setting key for 3 seconds. The dots
that separate the hours and minutes will flash but the
rest of the clock display will be hidden.

Water Hardness setting

The appliance features a system that automatically
indicates when it is time to descale.
The system can be optimised for households with
very soft water (also through using a water softening
appliance) and very hard water, by changing the user
settings to the relevant range of water hardness (see
table below).
To set the water hardness parameter, proceed as
follows:
Type
Soft water
Medium water
Hard water
7
Ca + Mg English deg.
(ppm)
0 to 150 0 to 11
151 to 350 12 to 25
501 to 500 26 to 35
To set the clock and the water hardness
parameter value proceed as described in the
following chapters.
3. Press again the Clock key to set the minutes. The
minute numbers will start to flash.
4. Press the "+" and "–" to set the correct minute
value.
5. To finish, press the Clock key again.
If you want to see the clock display again, press the
Clock setting key again for 3 seconds.
1. Press the Descale key. The hardness number will
start to flash on the Descale display (not necessary
if your Steam oven is first plugged in or after a
power failure).
2. Press the "+" and "–" to set the correct water
hardness parameter value, according to the below
table.
3. Press the Descale key to set the parameter. The
Descale display switches off.
Water hardness
French deg.
[°eH] [°dF]
0 to 15
16 to 35
36 to 50
German deg.
Display
[°dH]
0 to 8
9 to 20
21 to 28
1
2
3