Possible Faults - ABAC G-534 Notice D'utilisation

Pistolet à gravité
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 67
EN
covered by our warranty and we will have no responsibility for it. We reserve the right for technical improvements,
without prior notification.
This tool is designed to be used with suitable paintings as lacquers, water and solvent based paintings only. Never
use it for spraying gasoline, kerosene or other flammable fuels, and do not use with food or pharmaceutical
products, herbicides and pesticides.
Immediately shut down the equipment in case you hear unusual noises, or if a sudden power drop occurs. Check the
pneumatic tool and the compressed air supply system.
Pneumatic tool
Problem
The gun sprays irregularly.
Spray not uniform
The painting flows out even without
pushing the lever
Air leackage from nozzle without
painting
Compressed air supply system
-
compressor pressure is insufficient
-
pressure regulator not set on the correct pressure level, suitable to the tool being used.
-
there is a leak from the connection hose or from the connections (use Teflon tape or sealant paste)
-
leaks in the pneumatic system
-
filter or lubricator cogged
-
hose is crushed, pierced or too long (loss of pressure)
Any warranty is expressly waved in case of damages arising out of regular wear, overload, handling or use not
suitable for the tool. For this warranty to be applicable, the tool should not be dismantled when returned to your
retailer.
This warranty covers replaced parts and labor for a period of 12 months from the date of purchase (a proof of
purchase such as invoice or receipt is required).
Any defect may be removed by replacing the tool or repairing it, as the case may be.

POSSIBLE FAULTS

Possible Cause
Nozzle loosen
Painting density not correct
Nozzle hole dirt or damaged
Lever rod and nozzle dirt with dry painting
Lever rod and nozzle damaged
Painting passage clogged
Air passage clogged by painting
DISPOSAL
72
Solution
Tighten the nozzle
Verify painting density
Carefully clean the tool
Replace worn parts
Carefully clean the tool
Replace worn parts
Carefully clean the tool

Publicité

Table des Matières
loading

Table des Matières