Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CAUTION:
•
Since this manual refers to international standards, we recommend to previously obtain information on local safety regulations
and to make sure they are observed.
•
Compressed air is a potentially powerful power source, therefore use extreme caution when using the compressor or the accessory
kit.
•
Using compressed air requires knowing and observing any applicable regulation.
•
Do not allow unattended use by non – experienced staff. Keep children and animals out of the work area.
•
Assume a stable position to properly make use of the tool and grip it firmly.
•
Accidental and unexpected tool movement may represent a serious hazard.
•
Do not employ the tools in premises that have a potentially explosive atmosphere, or where there are dust deposits, gas pipelines
or electric duct-lines.
•
Operate the tool in a suitably ventilated environment only.
•
Pay special attention for processed materials that are highly flammable or to their potential explosion.
GENERAL SAFETY REGULATIONS
•
Do not use the equipment without the required safety devices.
•
Never hold the tool from the compressed air hose when carrying it.
•
Do not let other people approach the work area.
•
Do not aim the air jet or the tool in your direction or towards any other third party.
•
By all means, avoid direct contact with the tool engaged immediately after having used it, as its surface may be
very hot.
•
Do not touch the equipment moving parts during its operation.
•
Do not open nor modify in any way the tool or its accessories. Any repair should be carried out only by trained
staff.
•
Read and understand the contents of this manual before installing, operating, repairing, maintaining, changing accessories this
tool.
•
Only qualified and trained operators should install, adjust or use the tool.
•
Connect compressed air only when the equipment is shut down.
•
For tool optimum performance, make sure hose and connection size are those required.
•
Before starting up the tool, check its connection and make sure the compressed air hose is not damaged.
•
Before connecting the hose to the tool please check, whether the hose and the quick coupler are clean. Do this by letting air run
freely through hose and quick coupler.
•
Choose and replace the engaged accessory according to the instructions in the manual, in order to prevent unnecessary noise.
•
Use accessories that are suitable for the application and that are in compliance with the device, and connect them properly. Check
that they are being used as per instructions and that they are correctly installed.
•
Check the wear status of the tools and accessories before every use. Replace them if necessary.
WHAT YOU SHOULD DO
15
EN
Publicité
Table des Matières
