Hold Function; Inserting A Minidisc - Sharp MD-MT877H Mode D'emploi

Hold Function

The present operation condition can be kept even if
other buttons are accidentally pressed in a place such
as a crowded train.
Main unit
Press the • /– HOLD button for 2 seconds or more.
Release
Hold
If the battery is inserted or the AC adaptor is connected, you
can set this function even when the power is turned off.
Remote control unit
Move the HOLD switch to the safety position (direc-
tion indicated by the arrow).
Orange
mark
Hold
To cancel the hold mode:
Move the HOLD switch away from the safety position (the
opposite direction of the arrow).
If the hold function is active whilst the power is turned off,
the power cannot be turned on by mistake and the bat-
tery will not be drained.

Inserting a MiniDisc

2
1
4
When you record on a MiniDisc,
check that the erase prevention
tab is set to the "recordable" po-
Recording
Recordable
prevented sition.
Notes:
Do not place the MiniDisc under the holder.
If any resistance is felt, do not force the MiniDisc into the
unit, as it may cause damage to the unit. If resistance is
felt, remove the MiniDisc and reload it.
The lid cannot be opened if "TOC" is displayed refer to
the instruction on page 16.
3
E-12