Cleaning And Care - Beurer HK 25 Mode D'emploi

After switching on the heating pad, the setting starts flashing briefly, while the heating pad conducts
a self-test. Then the setting remains illuminated continuously.
3.3 Temperature settings
Level: 0 Off
1 Minimum heat
2 Medium heat
3 Maximum heat
3.4 Automatic switch-off function
The heating pad switches off automatically after approx. 90 minutes. The illuminated
temperature setting display then starts to flash. To switch on the heating pad again,
first set to ‚0' and then after approximately 5 seconds select the desired temperature
setting. Switch off the heating pad (0) or pull the plug out of the mains socket if you are
not going to use the heating pad after the automatic switch-off.
3.5 Fast heating hK 35, 40, 63
These heating pads have a fast heating function which allows them to heat up quickly
within the first 10 minutes.
3.6 Additional Instructions for HK 40 Moist heating pad
The HK 40 is also suitable for moist applications. For this purpose it is equipped with an additional
moisture-storing insert of fleece material. The heat transfer to the body is considerably improved
during moist use. Compared to a conventional, dry use of the heating pad, the moist heat is gene-
rally perceived as more pleasant.
For safety reasons, the textile covering and the insert may only be moisturised while the
heatingpad is disconnected from the power supply (with the power plug removed from the
electrical outlet).
To use when damp, sprinkle or spray the textile covering and the insert with water.
Before switching on the heating pad, always make sure that the textile covering and the insert
no longer drip, even when subjected to a higher press-on pressure! the switch must never
come into contact with water. Never allow water from an excessively damp covering to run
along the cable into the switch.
The plastic casing of the heating pad is watertight. Please make sure that the sleeve is never dama-
ged and do not use the heating pad if signs of damage or wear appear.
When using the (damp) heating pad, no essential oils or creams may be used.
These can result in damage to the plastic casing under certain circumstances.
You can also use the heating pad dry (without moistening it).
3.7 Additional information for HK 63 (
This heating pad has 6 integrated permanent magnets, which generate a homogeneous magnetic
field. Under certain conditions, static magnetic fields can have a favorable effect on the organism
and relieve pain. This heating pad can provide relief articularly in rheumatic complaints. However,
the heat pad must not be used in inflammatory diseases.

4. Cleaning and Care

4.1 HK 25, 35, 63
• Before cleaning the heating pad, always unplug it from the mains.
• The textile cover can be cleaned according to the symbols on the label, and for this purpose must
first be removed.
• Please note that the actual heating pad may not be machine-washed, spun or machine d ried,
chemically cleaned, wrung out, pressed or ironed.
0344)
8
90
min
STOP