Playing A Specific Track - Sony MDS-JE530 Mode D'emploi

Playing an MD
z
You can adjust the analog signal level output to the LINE
(ANALOG) OUT jacks and the PHONES jack
1 While the deck is playing, press LEVEL/DISPLAY/CHAR (or
DISPLAY) repeatedly until the line output adjustment display
appears.
2 Turn AMS (or press LEVEL +/– repeatedly) to adjust the
output signal level.
z
You can use Setup Menu to adjust the analog output level
While the deck is playing, select "Aout" in Setup Menu.
Note
When you eject the MD or turn off the deck, the output level is
reset to the factory setting (0.0 dB).
24
GB

Playing a Specific Track

While the deck is playing or stopped, use the procedure
below to quickly play any track.
AMS
H
Locating a track with AMS
To go to Do the following:
The next or a succeeding
Turn AMS clockwise (or press
track during play
> repeatedly).
A preceding track during Turn AMS counterclockwise (or
play press . repeatedly).
The beginning of the current Turn AMS counterclockwise (or
track during play press . once).
A specific track while the Turn AMS (or press ./>
deck is stopped repeatedly) until the track
number you want to go to flashes
in the display, then press AMS or
H.
Automatic Music Sensor
*
z
To locate the last track of the MD quickly
While the deck is stopped, turn AMS counterclockwise (or press
. once).
z
If you locate a track while the deck is stopped or paused
The deck will still be stopped or paused at the beginning of the
located track.
` / 1
A
Number
buttons
>
10
X . >
H
H
X
z x
./>
. >
m M
*