Creating Your Own Programme - Sony MDS-JE530 Mode D'emploi

Creating Your Own Programme

To enter a track number over 10 Z
Use >10. For details, see page 25.
To check the total playing time of the programme
Press LEVEL/DISPLAY/CHAR (or DISPLAY).
4
Repeat step 3 to enter other tracks.
The entered track is added to the location where the
"0" flashes.
Each time you enter a track, the total programme time
appears in the display.
5
Press YES.
"Complete!!" appears and the programme is
completed.
6
Press PLAY MODE repeatedly until "PROGRAM"
lights up in the display.
7
Press H.
Programme Play starts.
To stop Programme Play
Press x.
To resume normal play
Press PLAY MODE repeatedly until "PROGRAM" turns
off.
z
The programme remains even after Programme Play ends or
is stopped
Press H to play the programme again.
Notes
• If you turn off the deck or disconnect the mains lead, the
programme will be lost.
• The display shows "- - - m - - s" when the total playing time of
the programme exceeds 199 minutes.
• "ProgramFull!" appears when you try to programme 26th
track.
Checking the contents of the programme
While the deck is stopped and "PROGRAM" lights up,
press LEVEL/DISPLAY/CHAR (or DISPLAY) repeatedly.
The first several tracks in the programme appear in the
display. To see the rest of the programme, turn AMS (or
press ./> repeatedly).
28
GB
(Programme Play)
Changing the contents of the programme
While the deck is stopped and "PROGRAM" lights up, do
steps 1 and 2 of "Programming the tracks" on page 27,
followed by one of the procedures below:
To
Erase a track
Erase all tracks
Add a track at the
beginning of the
programme
Add a track in the
middle of the
programme
Add a track to the
end of the
programme
Replace a track
Do the following:
Press m/M repeatedly until the
number of the unwanted track flashes,
then press CLEAR.
Press CLEAR repeatedly until all the track
numbers disappear.
Press m repeatedly until "0" flashes
before the first track number, then do steps
3 to 5 of "Programming the tracks" on
pages 27 and 28.
Press m M repeatedly until the track
/
number which will precede the new track
flashes. Press AMS to display flashing
"0, " then do steps 3 to 5 of "Programming
the tracks" on pages 27 and 28.
Press M repeatedly until "0" flashes
after the last track number, then do steps
3 to 5 of "Programming the tracks" on
pages 27 and 28.
Press m/M repeatedly until the
number of the track to be changed flashes,
then do steps 3 to 5 of "Programming the
tracks" on pages 27 and 28.