Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DMX MODE CONFIGURATION
Press MENU to access the selection menu for system settings. Using the UP and DOWN controls, select the menu item "Mode" (bottom line) and
confirm with ENTER. Using the UP and DOWN buttons, select the submenu item "DMX" and confirm with ENTER. You can now select the desired
DMX mode with the UP and DOWN buttons (1CH, 3CH, 5CH) and confirm the selection with ENTER. Press MENU repeatedly to return to the main
display. The main display is activated automatically if no input is made within approximately 30 seconds. Tables with the channel assignment of the
different DMX modes can be found in these instructions under DMX CONTROL.
Menu
ENTER
Mode
UP/DOWN
CONFIGURE DMX START ADDRESS
Press MENU to access the selection menu for system settings. Using the UP and DOWN controls, select the menu item "DMX Addr" and
confirm with ENTER. You can now configure the DMX start address with the UP and DOWN buttons. Confirm the entry with ENTER and press
MENU once to return to the main display. The main display is activated automatically if no input is made within approximately 30 seconds. If
the main display is activated, the DMX start address can be changed directly by using the UP and DOWN buttons.
Menu
DMX Addr
ENTER
DMX Addr
001 – 512
UP/DOWN
STATIC MODE
Press MENU to access the selection menu for system settings. Using the UP and DOWN buttons, select the menu item "Mode" and confirm
with ENTER, then use UP and DOWN once again to select the menu item "Static". Confirm by pressing ENTER twice. You can now use the UP
and DOWN buttons to adjust the brightness of the spotlight with values from 000 (blackout) to 255 (maximum brightness). Confirm the entry
with ENTER and press MENU repeatedly to return to the main display. The main display is activated automatically if no input is made within
approximately 30 seconds. If the main display is activated, the brightness can be adjusted directly by using the UP and DOWN buttons.
Menu
ENTER
Mode
UP/DOWN
SLAVE MODE
Press MENU to access the selection menu for system settings. Using the UP and DOWN controls, select the menu item "Mode" (bottom line)
and confirm with ENTER. Using the UP and DOWN buttons, select the submenu item "Slave" and confirm with ENTER. Connect the slave and
the master units (same model) with a DMX cable and enable the standalone mode static on the master unit. Now the slave unit will follow
the master unit. Press MENU repeatedly to return to the main display. The main display is activated automatically if no input is made within
approximately 30 seconds.
Menu
ENTER
Mode
UP/DOWN
DEVICE SETTINGS
Press MENU to access the selection menu for system settings. Using the UP and DOWN controls, select the menu item "Settings" and
confirm with ENTER. This will take you to the submenu for setting the submenu items (see table, selection with UP and DOWN, confirm
with ENTER). Press MENU repeatedly to return to the main display. The main display is activated automatically if no input is made within
approximately 30 seconds.
Mode
DMX mode
ENTER
DMX
1CH
UP/DOWN
ENTER
Mode
Static
ENTER
Static
Dimmer
Mode
ENTER
Slave
DMX mode
DMX mode
/
/
3CH
5CH
Dimmer
ENTER
ENTER
000-255
UP/DOWN
ENTER
7
Publicité
Table des Matières
