Problems / Solutions: Flash Patterns And Their Meaning; Pedelec With Led Control Panel - Panasonic Pedelec Mode D'emploi

8.1 Problems / solutions: Flash patterns
and their meaning
If a problem occurs in the electrical system of your Pe-
delec, you should initially try to solve it by referring to the
following list which describes possible causes of errors
and ofers solutions. If the fault persists, consult your
specialist cycle shop.

8.1.1 Pedelec with LED control panel

ERROR CODE
24 III User Manual Pedelec with centre motor
CAUSE SOLUTION
No power assist. The Perform restart. The
power sensor could not system performs the
set itself correctly. calibration again. No
force should be applied
to the pedals during
this procedure which
takes roughly two sec-
onds.
No power assist. A Motor, sensor unit or
problem occurred in cable defective. Con-
the drive unit. tact your specialist
cycle shop.
The motor output is Allow the motor to cool
less. down and reduce the
The motor is over- assistance.
loaded.
The motor switches of. Allow the motor to cool
The motor is extremely down and reduce the
overloaded. assistance.
No power assist. Charge the battery im-
The battery is nearly mediately.
empty.