Automatic Switch-Of; Measurement And Display Ranges; Battery Charge State Indicator; Power Output Indicator - Panasonic Pedelec Mode D'emploi

4.2.1.8 Automatic switch-of

If you stop your Pedelec and it does not move for 10 min-
utes, the system switches of automatically. If you want to
use the assistance again, you will have to switch it back
on via the control panel.

4.2.1.9 Measurement and display ranges

DESCRIPTION
Speed
Journey length
Average speed
Top speed
Total journey length

4.2.1.10 Battery charge state indicator

Battery charge state indicator
This indicator helps you save power when riding which
means you can travel urther.
The remaining battery charge is shown in 5 stages.
16 III User Manual Pedelec with centre motor
DISPLAY RANGE
0.0 – 99.9 km / h
0.0 – 99999 km
(once the distance reaches
9999.9 km, this is dis-
played without a decimal
place.)
0 – 99.9 km / h
0.0 – 99.9 km / h
0.0 – 99999 km
(once the distance reaches
9999.9 km, this is dis-
played without a decimal
place.)
DISPLAY
5 LEDs light up •••••
4 LEDs light up ••••
3 LEDs light up •••
2 LEDs light up ••
1 LED lights up •
¡
1 LED lashes
no display –
E: Battery is empty
F: Battery is ull

4.2.1.11 Power output indicator

The power output indicator shows the actual power output
being requested and the actual power consumption in 6
stages (bars). This indicator helps you save power when
riding which means you can travel urther. The fewer of
the 6 bars that are displayed, the lower the actual power
output of the motor and the consumption. If more bars are
visible, the power output and consumption of the motor is
higher.
IF YOU CAN THE BATTERY IS SUPPLYING
SEE... A CURRENT OF
6 bars more than 20 amperes
5 bars up to 16 – 20 A
4 bars up to 12 – 16 A
3 bars up to 8 – 12 A
2 bars up to 2 – 8 A
1 bar up to 0 – 2 A
If the power consumption is very low, no bars are
displayed.
BATTERY CHARGE STATE
80 – 100%
60 – 80%
40 – 60%
20 – 40%
10 – 20%
< 10%
0%