Function Of Lcd Control Panel; On / Of Button; Selector Button For Display Panel; Changing The Assist Level - Panasonic Pedelec Mode D'emploi

4.2.1 Function of LCD control panel

4.2.1.1 On / Of button

Press the "On / Of" button to switch on the control panel
and drive.
The assist level that was active at the time the control
panel was switched of is automatically reinstated. The
back-lit display is turned on briely then goes out. All
recording of data (trip, actual journey length, average
speed, top speed, total journey length) starts as soon
as you switch the control panel on and stops when you
switch it of.

4.2.1.2 Selector button for display panel

You can display the information "Trip", "Average speed",
"Top speed" and "Total journey length" consecutively
by pressing the selector button for the display panel
("Mode").
The setting that was selected when you switched of is
also displayed irst in this case.

4.2.1.3 Changing the assist level

Increase power assist
The following assist levels are displayed one by one when
you press the button that increases the assist level: "NO
ASSIST / no assistance", "ECO / low assist level", "STAND-
ARD / medium assist level", "HIGH / high assist level", fol-
lowed once again by "NO ASSIST / no assistance". This
means that the amount of assistance increases each time
you press the button until you reach the highest level. If
you subsequently press the button, the assistance switch-
es of.
14 III User Manual Pedelec with centre motor
Reduce power assist
If you press the button that reduces the assist level, the
assistance reduces each time the button is pressed and
returns to the most powerul assist level when it reaches
the end of the loop.
In the "NO ASSIST / no assistance" mode, you ride the bike
normally without the assistance of the motor.

4.2.1.4 Resetting recorded data

If you press the selector button for the display panel for
longer than three seconds with the control panel switched
on, this resets the trip, average speed and top speed read-
ings to zero. You cannot delete the total journey length
using this method.

4.2.1.5 Switching the display on and of

The back-lit display and LCD control panel display can
also be switched on even if the drive is not enabled. To
do this, press the button that switches the lights on. The
drive remains in "NO ASSIST / no assistance" mode. Now
you cannot change the assist level.
If you press the light button when the control panel is
switched on, the back-lit display turns on.
If you press the light button when the light is on, the back-
lit display turns of. The power assist is still available and
you can change the assist level.

4.2.1.6 Deleting all data

Press the display ("Mode") selector button and the button
that deletes all data on the rear of the control panel at the
same time to delete all the data stored, including the total
journey length. The display then automatically switches
to settings mode for language, LCD contrast and wheel
circumference.