Dometic SC Série Notice D'utilisation page 14

Operation
6.4 Using the cooler in AC mode
(only SC30, SC30B, SC38)
➤ Place the device on a firm base.
➤ Connect the AC cable to the AC mains supply.
➤ Turn the cooling capacity control (fig. 2 6, page 3) to the desired position.
➤ Push the cold/hot switch (fig. 2 5, page 3) to the position "Cold" (cooling) or
"Hot" (heating) to switch the device on.
✓ The device starts cooling/heating the interior.
6.5 Devide the interior (only SC38)
You can devide the interior of the refrigerator as follows (fig. 4, page 4):
• No partition grille (A): Both coolers are actively cooled or heated.
• Open partition grille (B): The large cooling compartment is actively cooled or
heated. The small cooling compartment is less cooled or heated.
• Closed partition grille (C): The big cooling compartment is actively cooled or
heated. The small refrigerator compartment is passively cooled or heated.
I
NOTE
Mount the bar, even if you operate the cooling device without partition
grille, so that the lids can close properly.
➤ Mount the partition grille as shown (fig. 5, page 5).
14
SC26, SCT26, SC30, SC30B, SC38
EN