Cleaning The Appliance - CONSTRUCTA CK852 Série Mode D'emploi

Masquer les pouces Voir aussi pour CK852 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Cleaning the appliance

m
Caution
Do not use abrasive, chloride or acidic
cleaning agents or solvents.
Do not use scouring or abrasive
sponges. The metallic surfaces could
corrode.
Never clean shelves and containers
in the dishwasher. The parts may
become deformed!
Proceed as follows:
1. Before cleaning: Switch off
the appliance.
2. Pull out the mains plug or switch off
the fuse!
3. Take out the food and store in a cool
location.
4. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light.
5. Wipe the door seal with clear water
only and then wipe dry thoroughly.
6. After cleaning reconnect and switch
the appliance back on.
7. Put the food back into the appliance.
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out shelves in the door
Fig. '
Lift shelves upwards and take out.
Removing the container
Fig. (
Raise container at the rear and lift off the
extension rails.
To insert the container, place on the
retracted extension rails and engage.
Taking out the partition
Fig. )
Press levers on the underside on both
sides, pull partition forwards, lift and
swivel out to the side.
Taking out the vegetable container
cover
Lift cover, pull forwards and swivel out to
the side.
Inserting vegetable container cover and
partition
Fig. *
1. Insert vegetable container cover.
2. Insert partition.
Note
Before the partition can be inserted, the
humidity controller must be set to low air
humidity.
Remove telescopic rails
Fig. +
1. Pull out the telescopic rail.
2. Push lock in the direction of the arrow.
3. Detach telescopic rail from the rear
pin.
4. Push telescopic rail together, push
backwards above the rear pin
and disengage.
Installing telescopic rails
1. Place the extended telescopic
rail on the front pin.
2. Pull the telescopic rail forwards
slightly until it engages.
3. Place telescopic rail on the rear pin.
4. Push lock backwards.
en
37

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ck842 sérieCk852af30Ck842af30Ck842ef30

Table des Matières