General Operation - AEG BSS 4800 Mode D'emploi

English
26
First Use of the Device/Introduction
• Select a proper place for the device. A dry, level and slip
proof surface is suitable.
• Make sure the device is vented sufficiently!
• Remove the protective film from the device, if present.
Power supply
• Insert the grid plug into a properly installed three prong
socket with 230 V, 50 Hz. Connect the device with the
plug connector by inserting its plug into the DC IN 5 V
jack of the device.
• Make sure the grid voltage corresponds to the figures on
the rating plate.
CAUTION:
• The included AC adapter may only be used with this
device. Do not use it for other devices.
• Use only an AC adapter with 5 V (
AC adapter may damage the unit.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Battery Operation (Batteries not supplied)
• Open the lid of the battery compartment on the rear
side.
• Insert the 6 batteries type AA/R6 1.5 V. Observe the cor-
rect polarity (see bottom of battery compartment)!
• Close the battery compartment.
Should the device not be used for a long periods, remove
the batteries, to prevent any "leakage".
WARNING:
Do not expose the batteries to intense heat, such as sun-
light, fire or similar. Danger of explosion!
CAUTION:
• Different battery types or new and used batteries may
not be used together.
• Batteries must not be disposed of in the garbage.
Please bring used batteries to competent collection
centers or back to the dealer.

General Operation

Turning the device on/ off (7)
• Turn the device on by setting the ON/OFF switch to the
"ON" position on the rear side of the device.
• To turn off the device, set the ON/OFF switch to the
"OFF" position. Then, disconnect the device from the
mains.
NOTE:
After about 5 minutes without signal, the device will auto-
matically switch to standby.
Standby-/ Operating mode
• After you have turned on the device with the ON/OFF
switch (7), press the
the operating mode. The indicator lamp (10) will light up
in operating mode.
• To switch the device into standby mode, you need to
keep the
Volume
By pressing the / buttons (5) you can adjust the desired
volume.
Sound Settings
). A different
If necessary, change the EQ setting in your playback unit to
create the best sound.
Playing back music files
You have two options to playback your own music data with
the device: Wired or wireless via Bluetooth.
By cable (Cable not included)
1. Connect the 3.5 mm stereo RCA cable to an external
audio source. If required, use a suitable adapter (not
included).
2. Insert the other end of the cable into the AUX-IN jack (6)
on the unit. The device switches automatically into AUX
mode.
3. Start the playback of your audio source. Listen to the
sound playback via the speaker. You can adjust the
volume using the / buttons (5).
4. For the further procedure, please refer to the user manual
of the external audio source.
NOTE:
If possible, adjust the volume of the external unit to a com-
fortable level.
Cordless via Bluetooth
Bluetooth involves a technology for wireless radio connec-
tion of devices over a short distance. Devices with Bluetooth
standard are transmitting between 2.402 and 2.480 GHz in
the ISM band (Industrial, Scientific and Medical). Interference
can be caused for example by WLAN-networks, DAB radios,
cordless phones, or microwave ovens which work on the
same frequency band.
button (1) to switch the device into
button pressed down.