Parallel Connection; Top Cable Entry; Eyebolts - ALLTRONIC SEMIS Série Manuel D'installation

P
ARALLEL CONNECTION
UPS's can be connected in parallel to increase the reliability of power supply to the load (redundancy) and their power delivery.
Up to 8 units can be connected in parallel. Only units of the same power can be connected together in this way.
For example, the figure shows a parallel connection of two UPS's.
When UPS's are connected in parallel, the ECO (LINE INTERACTIVE), SMART (SMART ACTIVE) and STBYOFF (STAND-BY
OFF) modes are not available.
The optional parallel connection kit is required to connect multiple UPS's in this way.
For further information, see the parallel connection manual.
T
OP CABLE ENTRY
This is an optional accessory composed of a special cabinet for use with the UPS. It makes it possible to route the cables in at
the top.
E
YEBOLTS
This is a kit of brackets and fasteners for lifting the UPS from above and positioning it.
- 81 -