ALLTRONIC SEMIS Série Manuel D'installation page 105

UPS models
MODE AND EFFICIENCY
Operating mode
AC/AC yield in Eco mode
OTHER
Noise level with typical load
Casing degree of protection
(9)
Ambient temperature
Colour
(1) Maximum input current in the following conditions: nominal load (PF=1), 345V input voltage and batteries charging with 25A
(2) Nominal battery current in the following conditions: nominal load (PF=1), battery at nominal voltage
(3) @ 100% load & THDv ≤ 1%
(4)
To keep the output voltage within the specified precision, you may need to recalibrate the unit after it has been in service for a long time
If the mains frequency is within ±5% of the selected value, the UPS is synchronised with the mains
(5)
range of tolerance or in battery operation, the frequency is the one selected +0.01%
(6) Mains/Battery @ load 0% -100%
(7) @ Mains / battery / mains @ resistive load 0% / 100% / 0%
(8) Recharging current is automatically regulated in relation to the installed battery capacity
(9) 20 – 25 °C for increased battery life
FURTHER INFORMATION IS AVAILABLE IN THE INCLUDED "INSTALLATION INSTRUCTIONS"
SEMIS 160
True on line double conversion
Eco mode
Smart Active mode
Stand By Off (Emergency power supply)
Frequency Converter
Up to 99%
≤ 68B(A)
0 – 40 °C
RAL 7016
- 106 -
SEMIS 200
≤ 70dB(A)
IP20
. If frequency is out of the