Closing The Door; Replacing The Lamp; Installation; Electrical Connection - AEG SKS98840F1 Notice D'utilisation

64 www.aeg.com

7.2 Replacing the lamp

The appliance is equipped with a long-
life LED interior light.

8. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
This appliance should be installed in a
dry, well ventilated indoor where the am-
bient temperature corresponds to the
climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
SN
N
ST
T
Some functional problems might occur
for some types of models when operat-
ing outside of that range. The correct
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Only service is allowed to replace the
lighting device. Contact your Service
Center.

7.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
operation can only be guaranteed within
the specified temperature range. If you
have any doubts regarding where to in-
stall the appliance, please turn to the
vendor, to our customer service or to the
nearest Service Centre

8.2 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.