Destructeur De Documents Automatique - Olympia PS 33 Mode D'emploi

Problem Cause
Device does not Was the device in constant
work after lengthy operation for some time?
operation or Is the surface of the device
stops during warm?
operation
Paper jam Have you inserted more
than 6 sheets of paper (70
g/m²)?
Has the paper not been
inserted straight in the in-
feed slot?
If you cannot rectify the fault yourself, contact your dealer or call the Olympia hotline.
ATTENTION!
INPORTANT GUARANTEE DOCUMENTS
PLEASE STORE IN A SAFE PLACE.
Dear Customer,
Thank you for buying a quality product from
the device should develop a technical problem please observe the following
points:
The guarantee period for the device is 24 months.
Make sure that you store the purchasing receipt and the original packaging.
Should a problem occur, please call our hotline first:
+ 49 (0) 180/500 7514
(Fee for connections outside Germany: additional Euro 0.12
per call for the connection within Germany.)
Our personnel are often able to provide helpful advice over the phone.
If it is not possible to clear up the problem over the phone, please send the
device back to the following address:
Service-Center Hattingen
Weg zum Wasserwerk 10
45525 Hattingen, Germany
Guarantee repairs will only be performed if the purchase receipt is enclosed with
the device.
Thank you for your understanding.
Yours faithfully,
Your Olympia Business Systems partner
Remedy
Pull out the mains plug from the
socket and allow the motor to cool
down to room temperature.
Set the sliding switch to REV to
push back the paper. Switch the
device to AUTO again to shred the
paper remaining in the cutting unit.
Guarantee
. In the unlikely event that
PS-33

Destructeur de documents automatique

MODE D'EMPLOI
[FRANCAIS]
12.2005