REHASHOP Tiger Manuel D'utilisation page 8

1.4 Removable armrests:
1.4.1 Folding up the armrests:
Press the forward lever on the armrest to
GB
release the catch on the frame and enable
the armrests to be folded up.
1.4.2 Removing the armrests:
Press the forward lever on the armrest to
release the catch on the frame and enable
the armrests to be folded up. Now press
the rear lever to completely remove the
armrests.
1.4.3 Adjusting the height of the armrests:
Press the large button on the side of the
armrest with one hand and with the other
hand, position the armrest at the desired
height. Release the button and make sure
that the armrest locks into position.
1.4.4 Adjusting the horizontal position of
the armrests:
Press the little button which is located
directly on the armrest to enable the
armrest to be moved forwards and rear-
wards. Make sure that the armrest locks
into position again.
8
at
1.5 Adjusting the
angle of the front
wheels:
Use the 5mm hex
key to remove the
wheel mount. Now
position this at the
desired angle and retighten the screws.
1.6 Adjusting the
height of the front
wheels:
Remove the
fixing screws
and nuts from the
front wheels. Now
choose one of the three holes to attach the
wheels back to the mount. After tightening
the screws, check whether the wheels turn
freely. If not, you should slightly loosen the
screws and nuts, so that the wheels can
turn easily.
1.7 Adjusting the height of the rear wheels:
First, remove the wheels from the frame.
These can be easily
removed at the
touch of a button
(on the locking
mechanism in the
centre) thanks to
the quick-release
axles. Now remove the wheel mount and
its fixing with the help of the tool. You can
now reattach both components in one
of the holes in the wheelchair frame. The
wheels must then be reattached. To do
this, press the locking button and push
the wheel back onto the quick release axle.
Make sure that the rear wheels lock into
position on the quick release axle.
ch
verpleeg-
A L L E S W E E R Z O G O E D A L S V R O E G E R
nl