Dometic S4 Instructions De Montage page 10

Installing S4
See fig. 7
A
NOTICE!
Observe the sealant manufacturer's instructions.
➤ Seal the outer frame with a flexible non-hardening sealing compound (e.g.
SikaLastomer-710).
See fig. 8
➤ Place the outer frame in the middle of the wall section.
➤ Press the outer frame slightly onto the wall so that the packing compound
spreads out.
➤ Place the inner frame into the support strips on the outer frame and attach
it with the appropriate fastening screws (1).
Only fasten the screws slightly by hand.
(max. torque 3 Nm)
➤ Check that the roller blinds can move freely.
If the roller blinds cannot move freely, undo the screws (1) slightly.
➤ Cover the screw holes with the caps (2).
➤ Remove the protective film from both sides of the acrylic glass.
I
NOTE
If the protective film is exposed to sunlight for too long, it cannot
be taken off without leaving a residue.
➤ After installing, check the wall window works properly.
➤ If necessary, enter the new weight in the vehicle documents.
8
S4
EN