Electromagnetic Compatibility Information - Beurer EM34 Mode D'emploi

Electromagnetic Compatibility Information

Table 1
For all me equipment and me systems
• The device needs special precautions regarding EMC and needs to be installed and put into service according to the EMC information
provided.
• Portable and mobile RF communications equipment can affect device.
• The use of accessories or replacement parts, other than those sold/specified by the manufacturer may result in increased emissions or
decreased immunity of the device.
• The device should not be used adjacent to or stacked with other equipment and that if adjacent or stacked use is necessary, the device
should be observed to verify normal operation in the configuration in which it will be used.
Guidance and manufacture's declaration – electromagnetic emissions
EM34 is intended for use in the electromagnetic environment specified below. The customer or the user of EM34 should assure that it is used
in such an environment.
Emissions test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations/flicker emissions
IEC 61000-3-3
Compliance Electromagnetic environment – guidance
Group 1 EM34 uses RF energy only for its internal function. Therefore, its RF emissions are
very low and are not likely to cause any interference in nearby electronic equipment.
Class B EM34 is suitable for use in all establishments, including domestic establishments
and those directly connected to the public low-voltage power supply network that
Not applicable
supplies buildings used for domestic purposes.
Not applicable
48