FALMEC Plane NRS Livret D'instructions page 32

Phase 3
(Fig. F)
1) Insert the extension (H) in the chimney (G).
2) Fasten it all (G+H) to the hood body using the screws (V5).
3) Slide the extension (H) until it reaches the desired height.
4) Place the bracket (L) on the wall, verify the horizontal alignment with a spirit level and mark
2 drilling points at the ends.
5) Drill, insert 2 ø 4mm expansion plugs and fasten the bracket (L) with the relative screws
(V6).
6) Screw the extension (H) to the bracket (L) using the two screws (V7).
- Power the hood complying with the regulations in force (see sec. D of the booklet).
INSTRUCTIONS FOR ISLAND-MOUNTING OF HORIZON NRS, LUMINA
O2
NRS, PLANE NRS, VELA NRS HOODS
Phase 1
(Fig. A1)
- Identify the height H of the cooker resulting from the sum of the quotas: X + Y + H1
(Fig. B1)
- Following the indications in sec. H1, remove the perimeter suction panel (AP) (if present)
and the metal filters. Only for the Lumina NRS Island hood, remove the front panel (PN).
- Disconnect the male connector (CO) from the matching female connector fastened to the
hood body.
(Fig. C1)
- Loosen the 4 screws securing the NRS motor chamber (CM);
- shift the NRS motor chamber (CM) sideways to position the 4 screws against the hole
instead of the slot;
- lift the motor chamber (CM) upwards to remove it from the hood body.
(Fig. D1)
- Fasten the element (TI) to the NRS motor chamber (CM) with the 7 screws (V1).
(Fig. E1)
- Fasten the top trellis (TS) to the ceiling using the 4 Ø 8 plugs and relative screws (V2).
(Fig. F1 and G1)
- Measure the quota "Z" as indicated in figure F1.
- Cut the NRS pipe (A) and the NRS elbow (B) according to the indications in figure F1 part 2
so that the exhaust pipe (A) is installed perfectly vertical. Fasten the NRS elbow (B) to the
NRS pipe (A) with a clamp and connect it all temporarily to the exhaust pipe (F) set up on
the false ceiling or loft.
- Slide the whole set (CM+TI) on the trellis (TS) until reaching the desired height (H1) (also
see fig. A1)
- Secure the components (CM+TI and TS) with the 8 self-threading screws (V3).
Phase 2
(Fig. H1)
- Carefully insert the NRS pipe (A) in the motor fitting (D) of the motor chamber (CM) and
fasten it with 3 screws (V7).
(Fig. I1 and L1)
- Fasten the extension support elements (SP) to the trellis (TS) on the false ceiling or to the
motor chamber (CM) if the trellis (TS) is not used.
- Insert the chimney (G) onto the extension (H) and fasten them together with paper adhesive
tape.
30