Starting And Stopping; Before Starting; Connect A Power Source; Software Settings - Husqvarna PP65 Manuel D'utilisation

Before starting

WARNING! Please read the operator's
!
manual carefully and make sure you
understand the instructions before using
the machine.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
Make sure no unauthorised persons are
in the working area, otherwise there is a
risk of serious personal injury.
Check that the machine is assembled
correctly and do not show any signs of
damage.
• Perform daily maintenance. See instructions in the
section "Maintenance".
A gasoline or diesel driven generator can be used as a
power source if sufficiently powerful. See typical
generator operation cases in Technical Data. The
generator must be grounded to safeguard the function of
the power unit.
NOTICE! A generator which on some occasion
generates an input voltage outside the voltage range
specified in the technical data can damage the power
unit.

Connect a power source

When the machine has been transported to a suitable
site, it should be connected:
• Turn the switch to the OFF position (O).
• Connect the power unit to a grounded outlet
• Connect the tool to the power pack.
For maximum performance, the power pack must be
connected to a 3-phase outlet.
It is also possible to connect the power pack to a 1-phase
outlet (230 V), if you do not have access to a 3-phase
outlet. Then use the accompanying adapter cable. This
reduces performance.
For more information, see the "Technical data" section.
14 – English

STARTING AND STOPPING

Software settings

The following settings should be made before the power
unit is commissioned. See instructions in the "Menu
system" section for additional information.
• Set time and date. (SETTINGS>TIME & DATE)
• Select the required display language.
(SETTINGS>SET LANGUAGE)
• Select the required units. (SETTINGS>SET UNITS)

Starting

Check that the emergency stop button on the power pack
is not pressed in by turning the emergency stop button
clockwise.
• Turn the switch to the ON position (I).
• The connected tool is activated and this is shown by
the information shown in the display.
Follow the instructions in the manual supplied with the
connected tool.

Stopping

• Turn the switch to the OFF position (O).
Follow the instructions in the manual supplied with the
connected tool.