Starting And Stopping; Before Starting; Starting - Husqvarna PP 480 HF Manuel D'utilisation

Before starting

WARNING! Please read the operator's
!
manual carefully and make sure you
understand the instructions before using the
machine.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
Make sure no unauthorised persons are in
the working area, otherwise there is a risk of
serious personal injury.
Check that the machine is assembled
correctly and do not show any signs of
damage. See instructions in the section
"Assembling and adjustments".
• Perform daily maintenance. See instructions in the section
"Maintenance".
Before starting the saw, check that:
• The incoming electrical cable has been connected to a
fuse rated at least 16 A.
• All controls on the remote control have been set to zero
position. If this is not done, a message in the display will
prompt this when the start button is pushed.

Starting

• Check that the emergency stop button on the power pack
and the stop button on the remote control are not pressed
by turning the them clockwise.
• Turn the main switch to "1"-position.
14 –
English

STARTING AND STOPPING

• The power pack is activated and this is shown by the
indicator light shining. If the water valve is set to "AUTO" it
is now shut off. This valve opens again when the blade
rotation is started.
• Activate the remote control by pressing the "ON/OFF"
button.
ON/OFF
• WS 482 HF is fitted with two mechanical gears. State
which gear is set. (DRIVE CHOICES>SET GEAR) For
more information on recommended blades and speeds,
see "Recommended blade speeds" in the "Technical data"
section.
>>DRIVE CHOICES
SET GEAR
[GEAR 1]
SET DRIVE MODE
[BLADE]
SET ROT. DIR.
[STANDARD]
SET FUSE
[32A]
CAUTION! A higher speed than the
!
recommended speed can result in personal
injury and damage to the equipment.
OK
0
20 DEC 20:55