Pelgrim OST 353 Notice D'utilisation page 40

Combination of the
Pelgrim GKV106 gas hob
When the oven is built in under the GKV106
gas hob, the spark ignition box of the hob must
be fitted to the attachment plate at the back of
the dashboard of the oven.
1. Remove the middle control knobs of the
dashboard by pulling them towards you
(see fig. 11, 1).
2. Remove the screws (see fig. 11, 2), in order
to detach the cardan holders and the
attachment plate.
2
1
oven with the
1
fig. 11
3. Remove the decorative knob from the
attachment plate.
4. Fit the spark ignition box to the attachment
plate.
5. Screw the attachment plate and the cardan
holders firmly onto the dashboard again
(see fig. 12). Take care that the cardan
holders are fitted in the correct position.
6. Replace the control knobs.
fig. 12