Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To clear the tare value, please remove the container on the pan, then the
display will show a minus tare weight value and press
key again.
Note:
1. When performing the tare operation(s), make sure the instrument is in stable.
2. If consecutive tare operations have been performed, to clear the tare value,
please remove all the containers on the pan first and then press
key.
3. Tare range is the full capacity of balance for all models.
Units selection
Press the
key to choose the weighing units and the display will be
changed to the new value with the units shown. There are up to 8 units of
weight that can be enabled.
Overload alarm
When the weight on the pan exceeds the Max. capacity, the display will show
"--OL--" at the same time the buzzer sound. Please take off the weight at
once. Otherwise the load cell will be easy to be damaged.
Counting mode
In normal weighing mode, press the
key to enter into parts counting
mode. The display shows as below:
14
Publicité
Table des Matières
