Pioneer MUSIC TAP Elite X-SMC4-k Mode D'emploi page 38

13 Additional information
Problem
Power is not supplied to the
USB storage device.
Network
Problem
Cannot access to the
network.
Cannot access to the network
using WPS.
Cannot access to the
component or PC connected
via network.
Playback does not start.
The PC or Internet radio is
not properly operated.
38
En
Check
Does an error message appear in the
front panel display?
No power is supplied if the power
consumption is too high.
Check
The LAN cable is not firmly
connected.
The router is not switched on.
Network Type is set to Wired.
Internet security software is currently
installed in the connected
component.
The audio component on the network
which has been switched off is
switched on.
The component connected to the
network is not properly set.
There are no playable audio files on
the component connected to the
network.
The component is currently
disconnected from this unit or the
power supply.
The corresponding IP address is not
properly set.
The IP address is being automatically
configured.
Remedy
Turn the power off then back on.
Turn the power off, then disconnect and reconnect the USB storage
device.
Press FUNCTION / to switch to the other mode, then switch
again to the USB mode. (When the input is switched back to USB.)
Remedy
Firmly connect the LAN cable (page 8).
Switch on the router.
Network Type must be set to Wireless or Auto to use WPS
connection. See page 33 to change the network
type.
There are cases where a component with Internet security software
installed cannot be accessed.
Switch on the audio component on the network before switching on
this unit.
If the client is automatically authorized, you need to enter the
corresponding information again. Check whether the connection
status is set to "Do not authorize".
Check the audio files stored on the component connected to the
network.
Check whether the component is properly connected to this unit or
the power supply.
Switch on the built-in DHCP server function of your router, or set up
the network manually according to your network environment
(page 31).
The automatic configuration process takes time. Please wait.